
At the end of October 2023, another component of the turbine set for the gas-steam power plant under construction will arrive in Ostrołęka. This time it is a generator stator, which set off from the GE factory in Wrocław in the middle of the month. The device weighs 435 tons.
The generator stator is another piece of equipment manufactured in Poland. So far, steam turbine parts from Elbląg and a steam turbine condenser from Opole have been delivered to the CCGT Ostrołęka construction site. The construction of the gas-steam power plant in Ostrołęka is proceeding according to schedule – the progress of all works (design, procurement, delivery, and construction) reached nearly 52 percent at the end of September.
Such a heavy device requires appropriate logistics. Rail transport is the most convenient and proven method for this type of delivery. Measuring over 12 meters in length, the generator stator is traveling to Ostrołęka suspended between the platforms of a 32-axle transport wagon on special cranes. The entire transport set (stator and platforms) is approximately 62 meters long. Due to the dimensions and weight of the transported device, the speed on the route cannot exceed 20 km/h.
Additionally, ongoing monitoring of critical parameters, such as vibrations, humidity, and temperature, is being conducted to ensure that the nearly 900-kilometer journey takes place under optimal and safe conditions. The entire transit from the GE Power factory in Wrocław to the siding in Ostrołęka takes several days.
The generator will be part of the turbine set, the heart of the power plant in Ostrołęka. It will be driven in a single-shaft system by two turbines, gas and steam. Its task is to convert the mechanical energy produced by the rotating turbines into electrical energy. The generator is built from two parts – an internal rotor and a stationary external stator, which plays a key role in the entire device. It is in its electrical winding that the electric current will be generated, which is then transmitted to the transformer.
The generator stator is another piece of equipment, and also a part of the power plant’s turbine set, that was manufactured in Polish factories. So far, steam turbine parts from Elbląg and a steam turbine condenser built in Opole have been delivered to the CCGT Ostrołęka construction site. The generator rotor, on the other hand, will arrive from a Swiss GE factory.
Advanced investment
The construction of the gas-steam power plant in Ostrołęka is proceeding according to schedule – the progress of all works (design, procurement, delivery, and construction) reached nearly 52 percent at the end of September. The power block in Ostrołęka is one of the key projects of the ORLEN Group in terms of building low-emission sources to balance the National Power System (KSE). The investment in the gas-steam block in Ostrołęka will support both Poland’s decarbonization goals and those of the ORLEN Group itself. In its energy segment, the concern aims to reduce carbon dioxide emissions by 40 percent per MWh (megawatt-hour) by 2030 and to achieve climate neutrality by 2050.







