
What is worth separating in… pallets – part 1
The two pallet systems described in the previous issue of Logistyka, despite being legally separated (copyright protection and technical requirements for pallets), result in a synergy that allows for the safe use of dimensionally standardized pallets as tools in pallet racking systems.
It should be recalled that in the European Union, Directive 2009/104/EC of the European Parliament and of the Council of 16 September 2009, which specifies the minimum safety and health requirements for the use of work equipment by workers at work, is mandatory. Selected provisions of the Directive require that:
-
the employer shall take the necessary measures to ensure that the work equipment made available to workers in the undertaking or establishment is suitable for the work to be carried out or is properly adapted for that purpose and may be used by workers without impairment to their safety or health
-
when selecting the work equipment to be used, the employer shall pay attention to the specific working conditions, their characteristics and the hazards to the safety and health of workers which exist in the undertaking or establishment, particularly at the workstations, or any additional hazards resulting from the use of such work equipment.
The provisions of the Directive could significantly increase the length of this article, but that is not the point, because the reality for everyone is perhaps not quite so brutal, but cost-cutting to the point of absurdity caused by the “invisible hand of the market” can result in the effect shown in Figure 1.
The symbols of palletized unit loads, where only the pallets are marked in red, indicate detected pallet defects that eliminate them from further use. The types of defects are marked with letters in accordance with the drawing from Annex C to the PN-EN 15635 standard, provided in the first part of the article.
The red color of the load on the pallet combined with the abbreviation “load cap.” (on the bottom edge of the red field) indicates the absence of a specified pallet load capacity or a violation of markings reserved for pallet pool systems. Violation should be understood not only as blatant copyright infringement but also as the use of such markings on pallets that should never have been marked with them due to the quality of the raw material from which they were made or the workmanship itself.
The article comes from the magazine “Logistyka” 4/2012.







